MEANWell NEL-400-5 Switching Power Supply Manufacturer.
Gréisst:215×115×30mm.
Muecht: 400W.
Héich Effizienz bis zu 90%.
Built-in aktiv PFC Funktioun, PF>0.95.
LED Indikator fir Power op.
Forced air cooling by built in DC Fan with fan speed control function.
1U low profile 30mm
Héich Effizienz, Long life and high reliability
Schutzen: Kuerzschloss / Iwwerlaascht / Iwwer Volt / over temperature
1 Joer Garantie
MEANWell NEL-400-5 Switching Power Supply Manufacturer Product Specifications :
| Modell | NEL-400-5 | |
| Input | Voltage Range | 85~ 264VAC 120~ 370VAC |
| FREQUENCY RANGE | 47 ~ 63Hz | |
| AC CURRENT (Typ.) | 3.5A/115VAC 1.5A/230VAC | |
| LEAKAGE AKTUELL | <2mA / 240VAC | |
| INRUSH AKTUELL (Typ.) | COLD START 65A/230VAC | |
| EFFEKTIVITEIT (Typ.) | 84% | |
| Ausgang | BETECHTE AKTUELL | 80A |
| DC VOLTAGE | 5V | |
| BEwäert POWER | 400W | |
| AKTUELL RANGE | 0-80A | |
| VOLTAGED ADJ. RANGE | 4.5~ 5.5V | |
| RIPPEL & Kaméidi (max.) Note.2 | 150mvp-p | |
| VOLTAGE TOLERANCE Note.3 | ± 2,0% | |
| LOAD REGULATION Note.5 | ±1.5% | |
| LINE REGULATION Note.4 | ± 0,5% | |
| HOLD UP TIME | 20ms at full load | |
| SETUP, RISE TIME | 600ms,40ms at full load | |
| Schutz | OVER VOLTAGE | 5.6~ 7V Protection type :Shut off 0/p volltage, clamping by zener diode |
| OVER LOAD | Above 150% rated output power Protection type :Hiccup mode, recovers automatically after fault condition is removed |
|
| Sécherheet | WEIDER VOLTAGE | I/P-O/P:3KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC |
| SAFETY STANDARDS Note 6 | Spezifikatioune vun UL60950-1, CB(IEC60950-1),CCC GB4943, 1:2011 guttgeheescht | |
| Isolatioun Widderstand | I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH | |
| EMC STANDARD | EN55022 class B, EN61000-3-2,3, EN 61000-4-2,3,4,5,6,8,11, GB9254 | |
| Environment | SCHAFFT Fiichtegkeet | 20 ~ 90% RH non-condensing |
| SCHAFFT TEMP | -20 ~ +70 (Refer to output load derating curve) | |
| TEMP. COEFFICIENT | ± 0.03% | |
| STORAGE TEMP., Fiichtegkeet | -40 ~ +85 , 10 ~ 95% RH | |
| VIBRATIOUN | 10 ~500 Hz, 2G 10min./1cycle, 60min. all laanscht X, Y, Z axen | |
| Anerer | DIMENSIOUN | 215*115*30mm (L*W*H) |
| MTBF | 1608.8K hrs min. MIL-HDBK-217F Fotoen (25 ) | |
| Note | ech. Al parameters NOT specialy mentioned are measured at 230VAC input. rated load and 25??of ambient temperature. 2 Ripple & noise are measured at 20MHz Of bandwidth by usig a I2??twisted pair-wire terminated with a 0.1UI & 470 Parallel capacitor 3. Tolerance : includes set up tolerance. line regulation and load regulation. 4. Line regulation is measured from low line to high line at rated load. 5. Load regulation is measured from 0% zu 100% rated load. 6. For the request of GEl4943.1.the power soppy is only suable for use in the altitude 2000m below and the non tropical climate condrtion. 7. The power supply is considered a component which will be instated into a final equipment The final equipment must be re-confirmed that it still mesh EMC drectives. For guidance on how to perform the EMC tests. please refer to ‘EMI testing of component power supplies. |
|
Rezensiounen
Et gi keng Rezensiounen nach.